#Neato vacuum troubleshooting full#
#Neato vacuum troubleshooting download#

Select ‘Menu’ on the app or LCD screen.įollow the steps below to reset the Neato vacuum.

Remove your Neato from its charge base.

Keep in mind that turning off your vacuum will delete your clock settings and you will need to reset the clock when you turn on the vacuum.

You will have to turn off your vacuum because you plan to leave the house for a long time or to store the vacuum.

Take a dry lint-free cloth to wipe the dust off the vacuum’s top.

Use a clean, dry cotton swab to clean the two drop sensors on the vacuum’s underside.

Make sure you remove all the dirt and hair strands that are stuck in the brush bristles.

Use the cleaning tool to clean the side brushes.

Insert the filter back to the vacuum until it clicks securely, and then close the cover.

You have to replace the filter every one or two months or as needed.

Use the comb cleaning tool to brush off any remaining dirt on the filter.

Tap the vacuum’s filter over a garbage can to loosen any debris stuck on it.

Pop off the bin cover, remove the filter and empty the vacuum’s dirt bin.

When the charge begins to run low, it will go back to its charge base, recharge, and go back to cleaning where it left off. The vacuum will automatically leave the charging base and start cleaning.

Future vacuuming will always happen on the scheduled dates.

Then set the future vacuuming schedule, press ‘Menu’ and select ‘Schedule,’ set the day and time, and click on ‘Save.’.

Scroll down and click on Set Clock, and then scroll to select the current day, hour, and minute first and press ‘Save.’.

Set the current day and time for the vacuum to know when to start the next cleaning-Press ‘ Menu’, select 12-hour clock or 24-hour clock.

Depending on the model, you can control the cleaning schedule from the LCD Control Centre screen or the Neato app.

For efficient cleaning, you need to set a cleaning schedule for the robot.

The robot will do a maximum of three rounds of cleaning and return to its charging base.

If it did not finish cleaning, it will go back to its charging base, recharges, and then returns to the last spot it stopped cleaning to continue cleaning.

Press the ‘Start’ button again, and it will start vacuuming the floors room by room until it completes one battery charge.

Press the start button on the vacuum, and if it were on sleep mode, it would wake up.

You can control your Neato vacuum from the app or the LCD Control Centre screen.There will be a solid blue LED light that lasts about five seconds when the pairing is successful, and the LED light will turn solid red to indicate unsuccessful pairing. Your Neato robot is usually in pairing mode the first one hour after turning it on. Pair your robot to the app by turning on the robot.

#Neato vacuum troubleshooting download#

Download the free Neato app on your phone, create an account using a verified email address and connect your Neato robot.

#Neato vacuum troubleshooting full#

Ensure the vacuum charges full to ensure it cleans efficiently. An LED light on the vacuum will start blinking green and blue to indicate that it’s charging.

Place the Neato vacuum’s rounded side against the metal charging contacts on the charging base and push the metal contacts in completely.

Insert the power cord into the charging port on the charging base and plug the adapter into the power socket.

This clearance allows the vacuum robot to find its charging station. Place the charging base against the wall.Choose a power socket with no switch, and one gives about one meter of clearance on all sides.Remove the films and stickers from the device and its charging base to allow it to operate correctly.If you notice any damage, you should contact the Neato dealership. Unpack the Neato Vacuum from its carton packaging and inspect the device for any shipping damages.